This picture shows the finished unit. On the bottom I used rubber pads to cushion vibration and to limit how this unit may slide about during braking and hitting bumps in the road. The one rubber pad is height adjustable so one end of this unit can be higher to collect the rising bubbles that will be vented through a fitting at the top. The "T" fitting on the bottom contains the fill tube with a shut-off valve. The other side of the "T" fitting contains a clear tube that also attaches to the vent at the top so I can see how full this unit is at a glance. The water level should show in the tube making it easy to check without having t open the unit. The length of this unit is perfect for a location under the back seat of this car. The tube carrying the hydrogen/oxygen can easily follow the wiring harness back to the engine compartment from the location under the seat.

Previous Picture

Next Picture